Tesla Model S console insert (pre-refresh) - image

Files (4)

coinRamp.stl

STL

45.2 KB

mainBox.stl

STL

726.6 KB

rollTopInsert.stl

STL

2.8 KB

rollTopLid.stl

STL

187.5 KB

Print plan

Exact totals not supplied

Print setup plan

Useful setup guidance without pretending STL byte size can predict filament, cost, or print time.

4 model files

Material plan

PETG

Published material guidance; still check heat, UV, load, and printer compatibility.

Starting setup

25% infill

A planning starting point only; wall count, orientation, and geometry often matter more than infill.

Final totals

Confirm in slicer

Choose the needed variant, then slice it for grams, cost, and print time.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Unsure which one fits? Read the automotive filament guide.

Center Console

Tesla Model S console insert (pre-refresh)

1 downloads82 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

4 hosted model files

STL

Material start

PETG

Saved part guidance

Strength start

20-30% for durability and flexibility

Saved part guidance

Orientation / supports

verify in slicer

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a centre console for a Model S designed for my needs - might not fit yours:) The insert contains a large section for sunglasses, a section to hold gum, a "roll top" section for "stuff", a place to drop loose change and a place at the very rear for charging cards. When you print the main box, you can slide the rolltop in (when printed in PETG its flexible enough), the fit the coin ramp in to seal the end. No glue, or supports required - but you might need to play the rolltop in and out a few times to clear the channels. I added some cushioning on the bottom of the large section to help protect sun glasses, used a little bit more down the side to wedge the insert in place. In my car - the roll top section is printed in black and looks better for it, I've put in a red one for the photos so its easier to see.