Files (3)
Published material guidance; still check heat, UV, load, and printer compatibility.
A planning starting point only; wall count, orientation, and geometry often matter more than infill.
Slice the selected model with your final material, orientation, walls, and supports.
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Reference shelf
Recommended filament for this print
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| ABS filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ABS; use an enclosure and suitable ventilation, and verify temperature requirements and seller. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
Unsure which one fits? Read the automotive filament guide.
Tesla Model S Front Door Speaker Mount
Print this part
Use the part context as a starting point, then confirm geometry-dependent values in your slicer.
Files
3 hosted model files
STL
Material start
ABS
Saved part guidance
Strength start
medium to high infill for durability
Saved part guidance
Orientation / supports
verify in slicer
Exact totals
Slice for grams + time
Model geometry and final settings determine both
Vehicle exposure
Higher-heat material; verify location and load
Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
3DPrintedCarPartDescription
This is a speaker mount to replace the front door factory standard speakers on a Tesla Model S with Infinity Kappa 62.11I 6 1/2" speakers. It comes in two pieces as I didn't want to attempt a design as one with a bunch of supports. The speaker mount attaches to the speaker which then fits inside of the speaker base. You may need to do a little sanding for them to fit together as I did. They are then permanently "welded" together with acetone to create a tight bond. You must use abs filament for this to work. You may also want to put the two pieces together in an acetone vapor bath to prevent any layer separation since the Kappa speakers are considerably heavier than the factory speakers. Also included is the connector that attaches to the factory wire harnes on the door. Insert speaker wire into terminals and then insert into the connector. It will need a bit of force to get in. You can find the terminal on Amazon. Search for "MQD-1I 18-22 AWG 1/8" Male Tab Crimp Connector Solderless Terminal". Use hot glue or superglue to secure to connector.
Compatible Cars
Originally published on thingiverse.com by SCOTT HISHIKAWA (scotthi) · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
