Files (8)
Based on 25% main infill across listed model files
Filament only at roughly $24/kg PETG
Uses 70 mm/s, 0.2 mm layers; verify supports in slicer
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Reference shelf
Recommended filament for this print
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| PETG filamentAmazon · Affiliate link | Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
Unsure which one fits? Read the automotive filament guide.
Tesla Model Y Rigid Hatch Stops
Print this part
Use the part context as a starting point, then confirm geometry-dependent values in your slicer.
Files
8 hosted model files
STL
Material start
PETG
Saved part guidance
Strength start
20-30% infill for rigidity
Saved part guidance
Orientation / supports
Likely not needed
Exact totals
50 g · 2 hours
Saved estimate
Vehicle exposure
Cabin/interior use; avoid high-heat zones
Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
Michael ChenDescription
After picking up my Model Y I noticed that going over bumps or uneven roads there was a significant "boominess" in the cabin that created a low frequency, infrasonic sound that was quite irritating. After some research, I realized this problem is systemic to a lot of Model S and Model Y models because of slight movement of the rear hatch. After calibrating my rubber hatch stops with the "envelope trick" (https://www.youtube.com/watch?v=Z4fYt06sfN0), it didn't remove the issue completely. There was some discussion on Tesla Motor Club forums about making the two hatch stops more rigid to prevent any flex. Therefore I created these slip-on rigid hatch stops. They are a tight fit (I recommend printing with a 0.4mm nozzle)- if you adjust the size, you'll probably only want to do it by 0.5%.
Compatible Cars
Originally published on thingiverse.com · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
