Files (1)
Based on 25% main infill across listed model files
Filament only at roughly $24/kg PLA
Uses 70 mm/s, 0.2 mm layers; verify supports in slicer
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Toyota AE86 Corolla Trueno Silhouette
Print this part
Use the part context as a starting point, then confirm geometry-dependent values in your slicer.
Files
1 hosted model file
STL
Material start
PLA
Saved part guidance
Strength start
20-30% infill for a lightweight decorative piece
Saved part guidance
Orientation / supports
Likely not needed
Exact totals
50 g · 2 hours
Saved estimate
Vehicle exposure
Low-heat or decorative use only
Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
Michael ChenDescription
Calling all AE86 fans! As you know, this car the drift king legend, featured in Initial D. This is a 2-D wall silhouette for decoration. It is 250 x 80 x 2.5 mm, but you can scale it how you like. Set "Initial layer speed" to 20 mm/s for more precision.
Compatible Cars
Originally published on thingiverse.com · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
