Toyota Tacoma tailgate trekking pole holder - image

Files (3)

Tailgate_18mm_pole_holder_-_12mm_spacing.stl

STL

81.3 KB

Tailgate_18mm_pole_holder_-_17mm_spacing.stl

STL

55.6 KB

Tailgate_pole_holder_-_base.stl

STL

91.7 KB

Print plan

Exact totals not supplied

Print setup plan

Useful setup guidance without pretending STL byte size can predict filament, cost, or print time.

3 model files

Material plan

PETG

Published material guidance; still check heat, UV, load, and printer compatibility.

Starting setup

40% infill

A planning starting point only; wall count, orientation, and geometry often matter more than infill.

Final totals

Confirm in slicer

Choose the needed variant, then slice it for grams, cost, and print time.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Unsure which one fits? Read the automotive filament guide.

Trunk/Tailgate

Toyota Tacoma tailgate trekking pole holder

0 downloads70 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

3 hosted model files

STL

Material start

PETG

Saved part guidance

Strength start

40% or more for stiffness

Saved part guidance

Orientation / supports

verify in slicer, but likely needed beneath the larger hole in the base

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

UV/weather exposure — ASA is the starting point

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

These holders attach using the existing trim screws in the tailgate of a 3rd gen Tacoma. The base fits flush when tightened, and the screw head is recessed. I built them for trekking poles with a diameter of 18 mm. There are two versions of clamps, allowing for different gaps between the poles, 12 and 17 mm. The clamp part slides tightly into the base, but is not so tight that it can't be removed when not in use. 40% or more infill is recommended for stiffness. PETG is a better than PLA in this case, it is less brittle and stronger. The larger hole in the base faces down on the print bed, support is needed beneath that hole. The angled end should print ok without support.