VE Commodore / G8 Dash gauge pods

0 downloads193 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

Source link only

No hosted model files

Material

PETG or ASA for durability and heat resistance

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for strength and minimal weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Download the model at its source, then confirm the format is supported by your slicer. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

Download at source

License & use

CC BY-NC-SA

Link-only

Attribution required

Files stay with the original publisher; this catalog entry does not grant hosting or resale rights. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

I HAVE NOT RUN A TEST PRINT ON THESE! Measurements are revised from previous design, may still require slight sanding of lip to fit gauge. 3D printable Single, double and triple gauge pod options for Holden Commodore VE and Pontiac G8, designed specifically around Banks iDash but should fit other gauges. These install in the plastic center speaker grille, requires removal/modification of metal mesh. Played around with a design that didn't require cutting the support material from the plastic speaker grille but did not allow for as much movement to angle the gauges towards the driver.

Updated Jul 21, 2026

Originally published on thingiverse.com by William Fox (vonrottes) · License: CC BY-NC-SA