Volvo safety-belt-stopper

Plastic Replacement Parts to avoid to far retraction of Volvo rear seatbelts 2 x Created this to replace a usually missing stopper which could lead to a hassle to upright a folded down Volvo rear seat-backrest. The automatic rolling/unrolling mechanism has a car-rollover blocking latch, which does also activate when rear backrest is flat, and by doing so you will need tools, sometimes even need to remove the lower anchor-bolt to get enough free space in the seat belt to get your backrest of the rear seat upright again.. Most of the times the original stopper is missing causing this problem. This tiny plastic piece avoids that, will; leave enough space so seats can be up-righted without a hassle and these custom parts can be placed on the same position as the factory did place it (you will see a mark of that on the seat-belt) It will slide through the original hole in the fabric by using only the power of your finger/thumbnail, when placed a pair of pliers (and some cloth to prevent marking the stopper) will interlock both parts firmly and make a clicking sound when it does, made this version intentional a bit bigger as the factory-one, so it lays nice and flat on the fabric and covers up the markings of the old one.. Disclaimer: Do not drill,cut, puncture or use any force putting this in your car, and use it entirely at your own risk..