VW Armrest Latch (No Springs needed - PLA version)

Files (1)

VW_Armrest_Latch_No_Springs_Needed_PLA.stl

STL

2.1 MB

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

2 downloads197 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

(

Shared by

(EaziG)

Designers selling from the US, Canada, the UK, the EU/EEA (except Iceland), Switzerland and Gibraltar can also list separate original designs for sale and receive 80% of the listing price, paid out by Stripe in your local currency (conversion fees may apply). Claiming credits you here; it doesn't put this imported part up for sale.

Description

Summary This version uses no springs, and can be installed as is. in my case, the original latch, if printed in PLA, could warp over time. This was likely due to my arm rest only being able to support one spring on one side, so the pressure of the spring warped the clip. So this version does not use any springs, but still operates in the same way. for maximum strength, print on its side and use support (see image) Print Settings Printer: Creality CR10 mini Rafts: No Supports: Yes Resolution: 0.2 Infill: 100 Filament: ZERO PLA.