2/14.Timing Cover (new design) and Distributor for the Ford FlatHead V8

Print setup recommendations

• Material: PETG or ASA for durability in a hot engine environment
• Infill: 20-30% for most parts, 100% for live wires and covers
• Supports: verify in slicer
• Use a layer height of 0.15mm for detailed prints
• No raft or brim is recommended for these prints
• Check the orientation and support settings in your slicer for optimal results
• Handle fragile parts like 'TimingCoverDistributorTop' with care
• Consider using 4mmx2mm disk magnets for mounting if replacing the original model