Files (1)

gascaptetherloop.stl

STL

716.7 KB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Saved filament data plus editable planning inputs for cost and time.

1 model file

Recommended kit

50g

Based on 40% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg TPU / another flexible filament

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Accessories

Audi A6 Gas Cap Tether

0 downloads206 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

1 hosted model file

STL

Material start

TPU or another flexible filament

Saved part guidance

Strength start

low to medium infill for flexibility

Saved part guidance

Orientation / supports

Likely not needed

Exact totals

50 g · 2 hours

Saved estimate

Vehicle exposure

Flexible material; verify heat and load

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Michael Chen

Verified

Description

Gas Cap Tether for 2012 Audi A6. Should work with other car models too. Part Number on the gas cap is 3C0 20 553L. You must print in TPU or another flexible filament! PLA or ABS are too rigid for this purpose and will snap.