Files (1)

s10throttlekeep.stl

STL

26.1 KB

Print plan

Exact totals not supplied

Print setup plan

Useful setup guidance without pretending STL byte size can predict filament, cost, or print time.

1 model file

Material plan

PETG / ASA

Published material guidance; still check heat, UV, load, and printer compatibility.

Starting setup

100% infill

A planning starting point only; wall count, orientation, and geometry often matter more than infill.

Final totals

Confirm in slicer

Slice the selected model with your final material, orientation, walls, and supports.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Unsure which one fits? Read the automotive filament guide.

Mechanical/Functional

Chevy S-10 throttle cable clip

0 downloads82 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

1 hosted model file

STL

Material start

PETG or ASA for heat resistance and flexibility

Saved part guidance

Strength start

100% infill for durability, but adjust based on print requirements

Saved part guidance

Orientation / supports

supports unlikely

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

Engine-bay exposure — use rated material or OEM

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a throttle/cruise control cable clip for a 2001 Chevy S-10 with the 4.3L Vortec V6. The original clip degraded and broke allowing unwanted movement and rubbing on the cables. This is a 2 piece part that snaps together over the metal ferrule and then clips in to a plate over the engine to keep the cables from moving. Both the throttle and cruise control cables use the same clip....just oriented backwards (there is a tab on the clip that matches the notches on the cable plate). I used PETG as it is a good flexible and heat worthy material. I first tried PLA and the clip "wings" that flex during installation into the plate would break off. The PETG clips do not break and hold the cables in place very well (so far it's only been a few weeks of testing). Print at.2, 100% infill, no supports and print at a slower speed - I use 30mm/s. Hope this can help and let me know how it works for you!