Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Interior

Citroen DS3/C2/C3 Parcel Shelf Peg / Clip

1 downloads240 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Richard Hind (titchard)

Description

Spare Peg to hold the rope on a DS3 Parcel shelf. From looking up third party and official clips they appear to also be identical on the C2 and C3 so I am assuming they will also work there. I have only tested them on my DS3. These appeared hard to find in the UK - so took out my remaining one and with my callipers and 10 minutes in tinkerCAD came up with this. It's printed to 6.25MM for the width of the peg which showed up as 6.20mm on my callipers, but it fits snuggly into my car and holds the rope tight, its a bit harder to get the rope loop over than on the original but it won't come off by accident.