Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Side Skirts

F150 Rocker hole plugs 2009-2014

0 downloads326 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Josiah Whitefield (Problex)

Description

Plugs to go in the factory holes along the inside of the rockers on the 2009-2014 Ford F150's These holes are covered by tape from the factory, this tape eventually falls off and allows road grime and salt into the rockers which then rusts out. try print a few between 100% and 99% scale as some of the hole sizes varied slightly I used supports for these prints Also added TPU versions which seal much better, should work great for keeping road salt out over winter.