Gas pedal mount for E46

0 downloads362 views0 quality score

License & use

CC BY-NC

Link-only

Attribution required

Files stay with the original publisher; this catalog entry does not grant hosting or resale rights. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Ahamed Khan (Ahamed)

Designers selling from the US, Canada, the UK, the EU/EEA (except Iceland), Switzerland and Gibraltar can also list separate original designs for sale and receive 80% of the listing price, paid out by Stripe in your local currency (conversion fees may apply). Claiming credits you here; it doesn't put this imported part up for sale.

Description

If your BMW gas (drive by cable) pedal mount breaks off, and you don't want to rip all your carpeting out to weld in a new mount. this may be the solution for you. This should fit for any E46/36/39 drive by cable pedals (only been tested on an E46) This piece is meant to be put in the area where the previous mount was. recessed into the carpeting and touching the floor pan. The recess in the bottom of the part is meant for a bolt that has a 8.2mm diameter and 3mm deep head, with a 4.8mm threaded section. Although these dimensions can be altered to fit whatever hardware you may have. Rotate the piece so the two holes for the screw are facing the bottom. You are meant to drill the two small holes into the floor pan. and bolt it into place from underneath the car. (use a little bit of some rubber sealant to make sure it is weather proof) The OEM pedal has two tabs on either side of the lock tab that has to be shaved flat on the inside of the mounting part.