Earn money selling original 3D car part models.
Start sellingEarn money selling original 3D car part models.
Start sellingEarn money selling original 3D car part models.
Start selling
Reference shelf
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| PETG filamentAmazon · Affiliate link | Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region. | Check price at Amazon |
| ASA filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
victor turban (Superpfusch)This print clips in the compartment above the radio and has a very firm fit. (may scratch some surfaces but Golf4 are old enough that thats probably not a problem????) It has a hole to fit a USB cable through with a bit of a holding notch so the surplus cable length can be stowed in the compartment and won't be tugged out of it while driving. You may want to edit the size of the hole... The ballmount can be swapped with your own design and i used PT2.5x25 screws. (Often found in old electronic devices with plastic housings) The part that fits in the compartment is printed on its side for strength and a Material thats a bit more temperature resistant is probably a good idea for the summer, i printed it with PLA but it´s still winter...
Originally published on thingiverse.com by victor turban (Superpfusch) · License: CC BY-SA
Browse categories
Jump to interior, exterior, accessories, dashboard, mechanical, or tools hubs when you need a different kind of replacement part.
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Other projects by us
Building tools that make life easier
Start a fitment, printing, or design discussion with this part already attached.
