Files (1)
Based on 40% main infill across listed model files
Filament only at roughly $24/kg ABS / ASA
Uses 70 mm/s, 0.2 mm layers; verify supports in slicer
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Reference shelf
Recommended filament for this print
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| ASA filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability. | Check price at Amazon |
| ABS filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ABS; use an enclosure and suitable ventilation, and verify temperature requirements and seller. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
Unsure which one fits? Read the automotive filament guide.
Hyundai Sonata Dash Trim Clip
Print this part
Use the part context as a starting point, then confirm geometry-dependent values in your slicer.
Files
1 hosted model file
STL
Material start
ABS or ASA for durability and flexibility
Saved part guidance
Strength start
Low to moderate infill for a balance between strength and flexibility
Saved part guidance
Orientation / supports
Likely not needed
Exact totals
50 g · 2 hours
Saved estimate
Vehicle exposure
Windshield/dash heat — validate after a parked-car soak
Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
Michael ChenDescription
I recently swapped out the radio in my 2006 Hyundai Sonata, and in the process I discovered that there are a bunch of clips that hold the dash trim in place. These clips seem to have a tendency to get lost inside the vehicle, so I made a rough replacement part. I ended up using several when I was putting everything back together, they seem to work well enough although I believe they make for a slightly tighter fit than the original clips. Hopefully these come in handy for someone else! From what I can gather these clips are used on Hyundai vehicles from other years and in other models too - so maybe someone else will be after one someday. I'd recommend printing with a small nozzle - 0.4mm or below. I printed mine with a 0.8mm nozzle, and they didn't exactly come out pretty - but they did work, so close enough. Smaller nozzle is better, as these are pretty small parts. I'd recommend ABS, as you want these parts to have a decent amount of give before breaking.
Compatible Cars
Originally published on thingiverse.com · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
