Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Center Console

Jeep Grand Cherokee (WK2) Console bin with Redarc trailer brake fitting

0 downloads339 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

Safety/IP review

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Coho Carl (cohocarl)

Description

I needed to install a Redarc trailer brake on my '19 Jeep Grand Cherokee (WK2) (Quadra-Trac 1) and did not want to drill a hole in the center console or dash panel for the remote adjuster. The center shifter console pulls up easily, and there is plenty of room under the small storage bin for the remote. The small bin is easily removed by a couple clips molded into it. This print replaces the stock bin and it has the holes to mount the Redarc remote in it. It also makes the knob recessed a little so it is less likely to get damaged, but still enough room to adjust it. I have mine just resting in the center console with no issues. I may take a couple small dabs of silicone or 3m tape to secure it in, but I don't think it will be necessary. ***Original file "GCRedarc.stl" has been replaced with "GCRedarc2.stl" due to errors in the original file. Recommend using current file. (sorry).