Land Cruiser 200 - Auxbeam Switch Panel - Sunglasses Flip Down Insert Bezel

0 downloads96 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

Source link only

No hosted model files

Material start

ASA or ABS

Saved part guidance

Strength start

20-50% infill for durability

Saved part guidance

Orientation / supports

supports likely, verify in slicer

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

Higher-heat material; verify location and load

Download the model at its source, then confirm the format is supported by your slicer. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

Download at source

License & use

CC BY-NC-SA

Link-only

Attribution required

Files stay with the original publisher; this catalog entry does not grant hosting or resale rights. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a bezel that takes the place of the flip-down sunglasses holder in the Toyota Land Cruiser 200. Made for the Auxbeam 8-switch panel (Amazon link below). Pops into place of the sunglasses insert. The flip down portion is 2-pieces and this takes the place of one piece. Requires drilling a hole in the main plastic panel for the cable to pass through and move back and forth with the flip down. Recommend printing with ASA or ABS or some other high-temperature plastic. PLA would likely melt in the summer time in most places. I've printed anywhere from 0.15 to 0.3mm layer heights with good results. Also had the best success with supports on build plate since the bottom has an upward angle in one section to account for the curve of the piece that this fits in to. https://www.amazon.com/dp/B08FQTCLZG