Land Rover Discovery Rear Work Light Mount

0 downloads133 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

Source link only

No hosted model files

Material

PETG or ASA for durability in outdoor conditions

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for a balance between strength and weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Download the model at its source, then confirm the format is supported by your slicer. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

Download at source

License & use

CC BY-NC-SA

Link-only

Attribution required

Files stay with the original publisher; this catalog entry does not grant hosting or resale rights. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Just a quick, crude mount for a pair of work / off road reverse lights on a Land Rover Discovery II. Wires are fed in through the existing hole in the top of the door and routed through the existing wire tube. I wanted a mechanism to mount the lights on the rear door, without any permanent damage (no drilling holes or gluing). This just requires removing a rubber plug from an existing hole in the top of the door to run the wires through the door. The mounts are held on by the hook and then secured to the door with self-adhesive industrial strength low profile Velcro to prevent them sliding around. Printed in ABS, will see how long they stand up. Ideally, I'd make a better model, print at higher quality and paint them.. but they mount $7 lights from Amazon (Nilight 18W 4" Flood lights) a 1/4-20 x 1/2" stainless bolt & nylock nut holds the light to the mount.