Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Vents

Porsche 911 SC 91157101700 Klappe für Lüftung, flap for blower

1 downloads383 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

s3r3al kill4 (s3r3alkill4)

Description

This is a sparepart for Porsche 911 SC (g-Modell, 930) fresh air blower (Partnumber 91157101700). The former owner of my Porsche manipulated the ventilation and removed or lost one of the flaps in the fresh air blower housing. Printing: No support needed. Switch it to the flat side before printing. It may be necessary to scale the flap in x and y, depends on your printer. I used a 4mm foam rubber to seal the air stream. I used PETG because of high tempurature while heating.