Seat Back Latch - GM GMC Chevrolet Yukon Suburban Tahoe Avalanche - image

Files (1)

Seat_Back_Latch_-_GM_GMC_Chevrolet_Yukon_Suburban_Tahoe_Avalanche.stl

STL

11.5 MB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Saved filament data plus editable planning inputs for cost and time.

1 model file

Recommended kit

50g

Based on 100% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA / / ABS

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon
ABS filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ABS; use an enclosure and suitable ventilation, and verify temperature requirements and seller.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Unsure which one fits? Read the automotive filament guide.

Interior

Seat Back Latch - GM GMC Chevrolet Yukon Suburban Tahoe Avalanche

0 downloads285 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

1 hosted model file

STL

Material start

PETG, ASA, or ABS

Saved part guidance

Strength start

100% fill with zig zag infill or similar strong infill pattern

Saved part guidance

Orientation / supports

Likely not needed

Exact totals

50 g · 2 hours

Saved estimate

Vehicle exposure

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Michael Chen

Verified

Description

I loved the original design, but with my seat backs, the lip was just a little too short to hold up when hitting bumps. And once I started modifying it, I went a little further and upgraded the design a bit! These are pretty easy to replace, just slide the pin out and get these in place! Needlenose pliers are a must. For printing, print on the side as oriented in the model. Print at 100% fill and you shouldn't need supports. I printed at 0.2mm layer height with zig zag infill. It is very very strong and should last a long time. For heat tolerance, make sure to use PETG, ABS, or ASA. When you print yours, print out a spare or two just to have, even a couple to give away! Many of these break due to the terrible OEM design.