Shorty Center Console for NB Miata - image

Files (3)

Console_Split-_Rear.stl

STL

1.7 MB

Console_Full.stl

STL

2.9 MB

Console_Split-_Front.STL

STL

1.2 MB

Print guidance estimate

Uses saved filament metadata

Print cost & setup estimate

Saved filament data plus editable planning inputs for cost and time.

3 model files

Recommended kit

50g

Based on 25% main infill across listed model files

Material cost

$1.20

Filament only at roughly $24/kg PETG / ASA

Print time

2.0h saved / 1.4h–2.4h estimate

Uses 70 mm/s, 0.2 mm layers; verify supports in slicer

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Unsure which one fits? Read the automotive filament guide.

Interior

Shorty Center Console for NB Miata

0 downloads509 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

3 hosted model files

STL

Material start

PETG or ASA for durability in a car environment

Saved part guidance

Strength start

20-30% infill for a balance between weight and strength

Saved part guidance

Orientation / supports

Likely not needed

Exact totals

50 g · 2 hours

Saved estimate

Vehicle exposure

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

Michael Chen

Verified

Description

Shorty center console to cover up the gaping hole left behind when removing the stock transmission tunnel cover, as well as cover the lower shifter boot. This design allows you to use your stock NB Miata shifter boot and shifter boot retainer. You'll probably need to open up the screw holes on your boot retainer, but nothing that would prevent you from going back to stock. This attaches to the center stack using the stock screws from the original piece. HIGHLY HIGHLY recommend printing this upside down. If printed "right side up", the supports will be nearly impossible to remove without damaging/destroying the boot retainer screw pegs. For printing in one piece, have at it. I don't have experience with this printed whole, but I don't imagine it would be a problem. Just print upside down and with your favorite supports and temperatures. I don't have a printer large enough to do this in one piece, so I've included STL's to print in two pieces:.