Slim Keyfob Cover for Mini Cooper Gen 3

0 downloads28 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

Source link only

No hosted model files

Material

PETG

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-50% infill for a balance between durability and flexibility

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Download the model at its source, then confirm the format is supported by your slicer. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

Download at source

License & use

CC BY-NC-SA 4.0

Link-only

Attribution required

Files stay with the original publisher; this catalog entry does not grant hosting or resale rights. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

Summary Inspired by a similar design found on shapeways, I decided to make and upload my own design for a slim keyfob as it drastically decreases the size. This fits the newer model of keys only. Any observations, comments, etc. for improving the design will be highly appreciated. This is already my 10th iteration/revision of the design, each one with slight minuscule improvements for fitups. Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: Yes Supports: Yes Infill: 100% Post-Printing Installation The cover is supposed to be a tight fit. In order to install, remove the original cover by carefully pulling along the sides outwards to open slightly and pull out, then slide on this cover until it reaches a small block and then again gently pull on sides to widen the opening and it should then snap on.