Sony Xperia C5 Ultra car (Megane) ventialtion mount cradle - image

Files (2)

TelefoonHouderC5-2.stl

STL

513.6 KB

TelefoonHouderC5-HAAK.STL

STL

193.5 KB

Print guidance estimate

Slicer data required

Print cost & setup estimate

Setup guidance plus saved or slicer-confirmed filament, cost, and time. Model file size is never treated as printable volume.

2 model files

Typical selected file

Slice required

Choose the needed variant and slice it; source file size is not printable volume.

Material cost

Slice required

Use the slicer's filament total; STL/3MF byte size is not a cost input.

Print time

Slice required

Slice with the recommended material, infill, orientation, and supports.

STL file	Role	Source size	PETG / ASA 20%	PETG / ASA 25%	100% solid	Recommendation
TelefoonHouderC5-2.stl	Printable file	513.6 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer for optimal support generation
TelefoonHouderC5-HAAK.STL	Printable file	193.5 KB STL	Slice file	Slice file	Slice file	Ensure proper orientation in the slicer for optimal support generation

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Phone Mounts

Sony Xperia C5 Ultra car (Megane) ventialtion mount cradle

0 downloads44 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

2 hosted model files

STL

Material

PETG or ASA for durability in car conditions

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for a balance between strength and weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Open the STL, 3MF, or OBJ model in your slicer before printing. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

C5 is a huge phone, so mounting it in a car is a bit of a challenge. I made this custom cradle, so I coult place it neatly between the radio and ventilation. The mounting hooks, which are printed separately and thus could be made to fit other vehicles, hock over the bottom blades on the center console ventilation ducts. There are holes for the charger, mic and headphones. Also there is a hole on the back for the camera, but this is not so useful in my application. The cradle is pretty much designed to be used with the phone in a rugged cover (Aliexpress: http://goo.gl/UPvR9E ). Just the phone by itself will fall out. Other cases might work. This is pretty much the bigest thing i could print om my kossel delta mini (18cm) with the suports added.