Files (1)
Reference shelf
Recommended filament for this print
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| PETG filamentAmazon · Affiliate link | Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region. | Check price at Amazon |
| ASA filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
Unsure which one fits? Read the automotive filament guide.
Square hole bumper panel holder
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
3DPrintedCarPartDescription
This clip (or a slightly similar version of it) was missing on my Golf 7 R's rear bumper after being repaired. I'm sure it should be applicable where panels are being fit into other square 8mm holes. The flange is square 20mm. You need to rotate it 90 degrees so that the clip inserts print horizontally with the flatter side at the bottom - sorry, I don't know how to rotate it in Fusion 360, but is easy enough to rotate in your slicer. I've tested these with the universal Volkswagen 25-Hex screws which are usually used for the wheel arch inner liners as I had many spare. The hole is 4.5mm in diameter and 3mm at the tip, to flare open as the screw progresses. Should also work with other similar 4-5mm self-tapping screws. NB print with at least 5 outer layers in your slicer as this would provide the linear strength of the legs - even though the slicer won't adequately slice 5 lines everywhere, you need the legs' plastic to be continuously extruded to the flange.
Compatible Vehicles
Originally published on thingiverse.com by Dieter van der Westhuizen (dietervdwes) · License: CC BY
Browse categories
Browse other part families
Jump to interior, exterior, accessories, dashboard, mechanical, or tools hubs when you need a different kind of replacement part.
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Most specific car + model + year + category matches first, with popular parts mixed in.
