Subaru strut brace bracket

0 downloads47 views0 quality score

Print this part

Check the available model and saved setup details before opening your slicer.

Files

Source link only

No hosted model files

Material

PETG or ASA for durability and heat resistance

Print time

Slice to calculate

Filament

Slice to calculate

Supports

verify in slicer

Infill

20-30% infill for a balance between strength and weight

Difficulty

Not rated — inspect geometry

Vehicle heat

Cabin/interior use; avoid high-heat zones

Download the model at its source, then confirm the format is supported by your slicer. Confirm orientation, supports, print time, filament use, and printer compatibility. Test-fit before installing it in a vehicle.

Download at source

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

I needed a place to mount an aftermarket fuel pressure regulator in my Subaru Legacy GT, so I installed a strut brace and printed this bracket. You can find these strut braces on ebay from a few different vendors for about $50 in raw aluminum or $100 with a carbon fiber wrap. Note that the bracket is actually sized for a strut brace that is wrapped in carbon fiber (yay bling!) but it works well enough on the raw aluminum brace as well.