TEC Cup Holder Pad for BMW E39 5 Series M5 - image

Files (1)

TEC_Cup_Holder_Pad_-_Pad_Beveled.stl

STL

138.4 KB

Print plan

Exact totals not supplied

Print setup plan

Useful setup guidance without pretending STL byte size can predict filament, cost, or print time.

1 model file

Material plan

TPU

Published material guidance; still check heat, UV, load, and printer compatibility.

Starting setup

40% infill

A planning starting point only; wall count, orientation, and geometry often matter more than infill.

Final totals

Confirm in slicer

Slice the selected model with your final material, orientation, walls, and supports.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

TEC Cup Holder Pad for BMW E39 5 Series M5

0 downloads24 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

1 hosted model file

STL

Material start

TPU for flexibility and non-vibration surface

Saved part guidance

Strength start

medium to high infill for durability and 'catch' for drips

Saved part guidance

Orientation / supports

verify in slicer

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

Flexible material; verify heat and load

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a pad that sits on the TEC folding cup holder for the BMW E39 5 series. I found that my preferred travel mug was slightly too large of a diameter to sit completely down in the cup holder. Print this in TPU and it will create a nice, non-vibration surface. You can also print with zero bottom layers to expose the infill, which could also create a nice "catch" for any errant drips. Category: Automotive.