Tesla Supercharger No Support

After making the original and having a kid run up to my wife wanting to see her car, I decided we needed an easier to assemble and print version to hand out to the kids when that happens or at cars at coffee events. This is the beginners version of this object. Reduced tolerances slightly to make it easier to assemble, Raised Tesla Letters to not have to deal with the letter inserts which takes patience, just paint these if you want them red. Added chamfers for elephants foot reduction to make assembly easier if you printer is not perfectly calibrated on the Z Axis, reduced sharp edges in base to not nick your charge cable on the elephants foot if present, notched the base cap to allow easier tolerance there. Widened hole so USB A end will fit through base so when you fail to assemble in the right order it isn't a do over. A small drop of school glue will hold this model together nicely and not ruin your cable if you ever want to take it apart while being much easier to assemble and print. Kudos to the original model maker, this is a well done object, my printer's tolerances were not tight enough to assemble the original without a utility knife. This one works great and assembles in a minute or two instead 15-20 minutes. Looks identical except the raised lettering.