Toyota Gen 1 Hilux/Tacoma/4Runner/T100 Dash Switch Cover - image

Files (1)

toyota_switch_cover_improved_blank.stl

STL

2.1 MB

Print plan

Exact totals not supplied

Print setup plan

Useful setup guidance without pretending STL byte size can predict filament, cost, or print time.

1 model file

Material plan

ABS / ASA

Published material guidance; still check heat, UV, load, and printer compatibility.

Starting setup

25% infill

A planning starting point only; wall count, orientation, and geometry often matter more than infill.

Final totals

Confirm in slicer

Slice the selected model with your final material, orientation, walls, and supports.

Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.

Reference shelf

Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon
ABS filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ABS; use an enclosure and suitable ventilation, and verify temperature requirements and seller.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Unsure which one fits? Read the automotive filament guide.

Toyota Gen 1 Hilux/Tacoma/4Runner/T100 Dash Switch Cover

0 downloads2 views0 quality score

Print this part

Use the part context as a starting point, then confirm geometry-dependent values in your slicer.

Files

1 hosted model file

STL

Material start

ABS or ASA

Saved part guidance

Strength start

20-30% infill for strength, with 2-3 walls

Saved part guidance

Orientation / supports

verify in slicer, but likely needed when printing on its side

Exact totals

Slice for grams + time

Model geometry and final settings determine both

Vehicle exposure

Windshield/dash heat — validate after a parked-car soak

Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

3DPrintedCarPart

Verified

Description

This is a dashboard switch-hole cover plate for various older Toyota trucks and SUVs. The original came from the other thingi site, item number 2446920 by bgsteveg. I improved it by adding some gussets to keep the tabs from cracking off. Two additional STLs are included that have cutouts for one or two KCD11 rocker switches. This enables the use of inexpensive switches for automotive use. This should be printed in ABS, ASA, or some other high-temp plastic, since it would get soft and saggy at high temperatures in a truck cabin. I printed this face down with no supports from ABS, however I recommend this be printed on its side with supports to make the print a little stronger at the base of the tab. I added a photo of the essentially identical Toyota OEM part for comparison. Feel free to remix, modify, and enjoy this model! I gave this a CC-Attribution license so that the original creator gets credit where credit is due.