Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Tools & Jigs

Jeep Wrangler YJ - Fender Flare Nut Spanner + 13mm Hex Adapter

0 downloads345 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

Shared by

nilchaos

Description

Just a spanner I whipped up to aid in the removal of fender flare nuts on my 1994 Jeep Wrangler YJ. Has a hole down the middle for the tip of self tapping screws to poke through. Small fillets down side to aid in comfort if holding. I have also created a little hex head adapter for either a 13mm socket or spanner. Part group: EYJ-205 Part number: J400 4868 Onshape Link Here For both I'd recommend printing them at an angle (so the layer lines are not parallel to the direction torque is being applied). Though given that these shouldn't be heavily torqued it's more a safety net for corroded fasteners. Infill should be fairly high as well for the same reason. Supports are naturally required if you're printing at an angle - mandatory for the hex adapter but if printing the spanner flat then it'll be fine without supports.