Files (6)
Based on 25% main infill across listed model files
Filament only at roughly $24/kg ASA
Uses 70 mm/s, 0.2 mm layers; verify supports in slicer
Saved setup guidance is used for material, infill, support, and per-file recommendation text; editable numbers are planning estimates only.
Reference shelf
Recommended filament for this print
Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.
| Referenced item | What to verify | Price & availability |
|---|---|---|
| ASA filamentAmazon · Affiliate link | Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability. | Check price at Amazon |
Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.
Unsure which one fits? Read the automotive filament guide.
Mazda RX7 FC Heat Vent Gauge Pods
Print this part
Use the part context as a starting point, then confirm geometry-dependent values in your slicer.
Files
6 hosted model files
STL
Material start
ASA for its UV and heat resistance
Saved part guidance
Strength start
20-30% infill for a balance between durability and weight
Saved part guidance
Orientation / supports
Likely not needed
Exact totals
50 g · 2 hours
Saved estimate
Vehicle exposure
Higher-heat material; verify location and load
Open the STL, 3MF, or OBJ model in your slicer before printing. Exact grams, time, and final support placement come from the actual slice. Test-fit and heat-check the part before installing it in a vehicle.
License & use
The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.
Shared by
Michael ChenDescription
This is a replacement center bezel for an FC Mazda RX7 heating vent to allow for the placement of 3 x 2-1/16" diameter gauges. I have uploaded both a combined and fully separate set of STL's. I recommend printing this in ASA for both UV and heat resistance given it's location in the vehicle. This project requires the use of the factory metal retention clips that came with the original center vent assembly (4) The lower ones are very tight and should be installed carefully using a vise, or pliers such as the Knipex adjustable 86 series. The required files are as follows: Separate version: (Easier to print. No support needed) 1 x Center Vent Insert_Base.stl 1 x Center Vent Insert_Pods_Combined.
Compatible Cars
Originally published on thingiverse.com · License: CC BY
Share whether this print actually fits a real car. Installed photos and material notes make the catalog more trustworthy.
Related Parts
Finding specific fitment/category matches first.
