Recommended filament for this print

Product references matched to the published material guidance. Confirm diameter, heat resistance, colour, and printer compatibility.

Referenced item	What to verify	Price & availability
PETG filamentAmazon · Affiliate link	Amazon product page for 1.75 mm PETG; confirm colour, spool size, print temperature, seller, and delivery region.	Check price at Amazon
ASA filamentAmazon · Affiliate link	Amazon product page for 1.75 mm ASA; use an enclosure and suitable ventilation, and confirm seller and regional availability.	Check price at Amazon

Affiliate disclosure: if you buy through an eligible link, 3DPrintedCarPart may earn a commission at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Confirm product specifications, compatibility, seller terms, and vehicle safety before ordering or using anything. Amazon may redirect you to a nearby supported store; otherwise the original Amazon.com page remains available.

Cup Holders

Tacoma iPhone dock

0 downloads316 views0 quality score

License & use

CC BY

Commercial use allowed

Attribution required

The file license permits commercial reuse, subject to any applicable attribution or share-alike terms. License status does not verify vehicle fitment, OEM rights, design patents, or safety.

(

Shared by

(PrefectPitch)

Description

This is a docking station that fits in the middle of the front cup holder in a 2022 Tacoma (or any 4th gen). It is sized to fit an iPhone 12 Pro Max, but would probably fit the 13 & 14 Pro max as well. It replaces the OEM plastic divider and uses that slot as a friction fit, it needs to be tighter so that it doesn't pull out, but that is a WIP. I'm using a right-angle cable that is held tight to the base with a 3mm plate that fits over the connector. The plate can be made to fit very tightly with a bit of elephant foot, or an increased flow rate for the first couple of layers. This is the cable I use: https://www.amazon.com/gp/product/B07L81LLN2 Infill at 10-20% is fine, no supports are needed. Any suggestions or requests for different sizes are welcome.